Skip to content
Bills from the 2013–14 session

Assembly Bill 381

The definitions of an all-terrain vehicle and a utility terrain vehicle, restrictions on operating an all-terrain vehicle or a utility terrain vehicle on a roadway, and seating requirements for utility terrain vehicles

Stopped before the full Assembly voted

The recommended passing it, but the full Assembly never voted on it. To try again, a lawmaker would have to start a new bill.

  1. Introduced, passed

    Sep 20, 2013

  2. Committee, passed

    Approved

  3. Assembly vote, stopped here

    Stopped here. The full Assembly never voted on it.

  4. Senate vote, not reached

  5. Governor, not reached

  6. Law, not reached

Latest entry in the official record, Apr 8, 2014: “Failed to pass pursuant to ⁠”

Read the bill

Following saves it on this device. New actions show on your Following page. You can also get updates in a feed reader.

What it would have done

Summary by the , the Legislature's nonpartisan drafting office. It's their wording, not ours.

Under current law, the Department of Natural Resources administers the laws relating to the operation and registration of all-terrain vehicles (ATVs) and utility terrain vehicles (UTVs). Current law provides that a device qualifies as an ATV or a UTV if it meets certain requirements. Among the requirements for an ATV is that it is designed by the manufacturer to travel on three or more low-pressure tires. A UTV must be either originally manufactured with four or more low-pressure tires or be designed by the manufacturer to travel on 3 or more low-pressure tires depending on whether the UTV meets certain other requirements. This bill changes these tire requirements so that the tires may also be non-pneumatic tires. The bill provides that a non-pneumatic tire is a tire that, as designed by the manufacturer, has a minimum width of six inches, has a reinforced structure, and is not supported by air pressure. The bill also provides that in order to qualify as an ATV or UTV, the vehicle must have been commercially designed and manufactured with the requisite specifications.

Under current law, a device qualifies as a UTV if it weighs more than 900 pounds and meets certain other requirements. This bill specifies that a device does not qualify as a UTV unless it also weighs no more than 2,000 pounds.

Read the full summary

Under current law, a UTV that meets certain requirements must have seats, designed not to be straddled, for at least two occupants. This bill eliminates this requirement. The bill does not change current law that requires certain other UTVs to have a seat designed by the operator to be straddled. The bill also prohibits a person from operating a UTV while seated on or allowing other occupants to be seated on a seat that is not original to the UTV as manufactured.

Who's behind it

22 lawmakers are its ⁠. 17 are Republicans and 5 are Democrats.

13 more lawmakers ⁠.

See all 35 names

Authors (22)

Signed on in support (13)

Versions and amendments

Every text the Legislature printed for this bill, including proposed changes. Each opens on the Legislature's site.

How lawmakers voted

There were 2 votes on this bill.

Assembly Committee on Natural Resources and Sporting Heritage vote on an amendment

Passed, 15 to 0 · Oct 9, 2013

No member-by-member record exists for this vote. Committee votes and some older sessions record totals only.

Official motion: “Report Assembly Amendment 1 adoption recommended by Committee on Natural Resources and Sporting Heritage, Ayes 15, Noes 0”. Official record · This vote on its own page

Assembly Committee on Natural Resources and Sporting Heritage vote to recommend it

Passed, 15 to 0 · Oct 9, 2013

No member-by-member record exists for this vote. Committee votes and some older sessions record totals only.

Official motion: “Report passage as amended recommended by Committee on Natural Resources and Sporting Heritage, Ayes 15, Noes 0”. Official record · This vote on its own page

What happened

  1. Apr 8, 2014

    The session ended, and the bill died with it.

  2. Oct 15, 2013

    1 more representative signed on in support.

  3. Oct 9, 2013

    Sent to the Assembly Committee on Rules.

  4. Oct 9, 2013

    The committee voted to recommend passing it, 15 to 0.

  5. Oct 9, 2013

    “Report Assembly Amendment 1 adoption recommended by Committee on Natural Resources and Sporting Heritage, Ayes 15, Noes 0” (the official wording)

  6. Sep 25, 2013

    The committee held a public hearing.

  7. Sep 20, 2013

    Sent to the Assembly Committee on Natural Resources and Sporting Heritage.

  8. Sep 20, 2013

    Introduced in the Assembly.

See the official record, word for word
  1. Sep 20, 2013 · Assembly

    Introduced by Representatives Severson, A. Ott, Bernier, Czaja, Danou, Krug, T. Larson, Marklein, Milroy, Mursau, Nygren, Petryk, Ringhand, Ripp, Smith, Spiros, Steineke, Swearingen, Tauchen, Wright, Endsley and Kuglitsch; cosponsored by Senators Harsdorf, Petrowski, Tiffany, Vinehout, Cowles, Moulton, Kedzie, Leibham, Shilling, Grothman, Lassa and Hansen

  2. Sep 20, 2013 · Assembly

    Read first time and referred to Committee on Natural Resources and Sporting Heritage

  3. Sep 25, 2013 · Assembly

    Public hearing held

  4. Oct 3, 2013 · Assembly

    Assembly Amendment 1 offered by Representative Severson

  5. Oct 9, 2013 · Assembly

    Executive action taken

  6. Oct 9, 2013 · Assembly

    Report Assembly Amendment 1 adoption recommended by Committee on Natural Resources and Sporting Heritage, Ayes 15, Noes 0

  7. Oct 9, 2013 · Assembly

    Report passage as amended recommended by Committee on Natural Resources and Sporting Heritage, Ayes 15, Noes 0

  8. Oct 9, 2013 · Assembly

    Referred to Committee on Rules

  9. Oct 10, 2013 · Assembly

    Placed on calendar 10-15-2013 by Committee on Rules

  10. Oct 15, 2013 · Assembly

    Placed on calendar of 10-15-2013 following Assembly Bill 297

  11. Oct 15, 2013 · Assembly

    Representative Barca added as a coauthor

  12. Oct 15, 2013 · Assembly

    Laid on the table

  13. Apr 8, 2014 · Assembly

    Failed to pass pursuant to Senate Joint Resolution 1

Terms on this page

Committee

A small group of lawmakers that looks at a bill first. Most bills never leave committee.

More in the glossary

Senate Joint Resolution 1

The session's calendar. Any bill not passed by its last voting day dies.

Official term: Failed to pass pursuant to SJR 1. More in the glossary

Legislative Reference Bureau

The Legislature's nonpartisan office that drafts bills and writes the summary at the top of each one.

Official term: LRB analysis. More in the glossary

Author

A lawmaker who formally puts a bill forward. The text itself is drafted by the Legislative Reference Bureau.

Official term: Author, coauthor. More in the glossary

Signed on in support

Lawmakers who back a bill without being one of its authors, often from the other chamber.

Official term: Cosponsor. More in the glossary

Roll call

A vote where each lawmaker's yes or no is recorded by name.

Official term: Roll call vote. More in the glossary

From the Wisconsin Legislature's official record, checked Sep 15, 2026. See the source

Committee

A small group of lawmakers that looks at a bill first. Most bills never leave committee.

Senate Joint Resolution 1

The session's calendar. Any bill not passed by its last voting day dies.

Official term: Failed to pass pursuant to SJR 1

Legislative Reference Bureau

The Legislature's nonpartisan office that drafts bills and writes the summary at the top of each one.

Official term: LRB analysis

Author

A lawmaker who formally puts a bill forward. The text itself is drafted by the Legislative Reference Bureau.

Official term: Author, coauthor

Signed on in support

Lawmakers who back a bill without being one of its authors, often from the other chamber.

Official term: Cosponsor

Roll call

A vote where each lawmaker's yes or no is recorded by name.

Official term: Roll call vote